I am looking for a low profile seat ( I know this is the 1/4 mile forum just give me a minute ). I went to the corbin site and under there seat description they said you needed an NHRA license to run a ZX14 on the drag strip so my question is two fold is it true you need a license and does anyone know of a good low profile seat.
 |
 |
 |
 |
 |
 |
 |
Welcome to zx14ninjaform.com!
You are not logged in.
Page: 1
Created on: 06/16/12 09:57 PM
Replies: 3
Danno
Location:
Southwestern Illinois
Joined: 12/18/11
Posts: 2142
RE: nhra
07/07/12 7:42 AM
I have a Tobin seat f/s in the For Sale/Trade section that's about 1" lower than stock and the bumstop is closer to the tank than stock.
http://www.zx14ninjaforum.com/messages.cfm?threadid=FC4669AC-D56B-84E2-10E32FC24936748B
* Last updated by: Danno on 7/7/2012 @ 7:44 AM *
'07 CPB Blue; ZGST windscreen with MRA X-screen adjustable spoiler, tube bar adaptor, PC III, ATRE,BMC air filter, modified stock seat with 2nd Look cover,Scorpion Flame Ti slip-ons, Galfer rotors front and rear, braided-stainless lines, C-F 10R front fender, C-F hugger, C-F inner fairing panels, painted foreman's fins with faux C-F inlay, polished rim lips wired for heated gear and accessories, Givi V35 side bags and E41 topcase with SW-Motech qd mounts
KoflaOlivieri
Location:
Philadelphia, PA
Joined: 02/17/12
Posts: 1805
Danno
Location:
Southwestern Illinois
Joined: 12/18/11
Posts: 2142
RE: nhra
07/13/12 12:30 PM
Tobin seat has been SOLD.
'07 CPB Blue; ZGST windscreen with MRA X-screen adjustable spoiler, tube bar adaptor, PC III, ATRE,BMC air filter, modified stock seat with 2nd Look cover,Scorpion Flame Ti slip-ons, Galfer rotors front and rear, braided-stainless lines, C-F 10R front fender, C-F hugger, C-F inner fairing panels, painted foreman's fins with faux C-F inlay, polished rim lips wired for heated gear and accessories, Givi V35 side bags and E41 topcase with SW-Motech qd mounts
Welcome to zx14ninjaform.com!
Page: 1
New Post
Please login to post a response.