2011 Gen 1. I have no speedometer and the odometer is froze and will not function. The speed sensor has been replaced. Anyone had this issue? Thanks.

Did you check the sprocket nut the sensor gets its count off of? If the nut is caked with grease, that might interfere with the signal. You know the old file off two corners of the nut trick to cut the speed reading in half? Maybe all of your corners are covered in chain grease. Long shot but all I could think of.

Otherwise, remove the maine wiring harness plug from backside of multifunction meter and do the diagnostic tests with a probe. It's in the SM.

I concur with Rook. I can pull grease out of the clutch slave cover so it's not lube per say. So with the swap of a good known part, it's up at the dash next to diagnose off of.