How To Download and Install Dynojet Softwares
Go to www.powercommander.com
1. Click ACCESS RACE READY FUEL INJECTION MODULE SITE (the photo of the race bike) to open the Power Commander page. 
2. The Power Commander page opens.
Click DOWNLOADS from the grey bar at the top of the screen to open the Power Commander Downloads page.
3. The Power Commander Downloads page opens.
Click the access downloads box for the device associated with the software you want. This will bring you to the Downloads page for that device.
4. The Downloads page for chosen device opens.
Choose the download you want from the Software, Firmware or Manual bar.
Click the Download icon.
The selection will download to your computer.
5. Access the file from your downloads and click to install. 
6. The Dynojet Setup Wizard will open.
Close all other applications and click Next.
7. Select Destination Location will open to ask you where you want the software installed to.
Click Browse and select Desktop or the software will install to your C drive by default.
8. Select Start Menu Folder will open with the default location being the Dynojet software selected.
Click Next.
9. Select Additional Tasks will open.
Select Create a desktop icon and click Next.
10. Ready to Install will open. Review the installation selections you made.
Click Back if you wish to change any selections.
Click Install when you are ready to install the software.
11. Completing the Dynojet Setup Wizard will open.
Click Finish.
12. Your security software will probably ask you to verify that you want the software from an unidentified source to make changes to your computer.
Click Yes.
13. The Dynojet software that was just installed will open.
The installation is complete.
X out to close the Dynojet software. 
* Last updated by: Rook on 1/16/2018 @ 3:52 PM *